Product Description

* FOR 2" TANK DRAIN TOILETS * Remember the last time your toilet tank leaked and you struggled underneath to remove those corroded tank bolts? Doing the job RIGHT requires quality seals that won't leak and stainless steel hardware that resists corrosion over time. Our exclusive Compression Cone Seals end tank leaks, while our Stainless Steel Bolts and Wingnuts make installation and removal a breeze. Includes 2" tank-to-bowl SoftSeal gasket for a complete tank mount job.

Installation Tips: On each bolt, slip the flat side of the Compression Cone Seal against the bolt head such that cone is pointing downward as shown above. Pass the assemblies thorough the holes inside the tank and fasten each with a metal washer and small 1/2" nut (omit these if the tank-to-bowl spacing does not have enough clearance). Tighten enough such that the Cone Seals just start to bulge under the bolt heads inside the tank, usually 1 to 2 turns after finger tightening . . . DO NOT OVERTIGHTEN.

Once the tank is in place, fasten on with the rubber washers, metal washers and then the wingnuts. Finger tighten the wingnuts just enough to snug up the tank, usually another 1 to 2 turns additional turn they start to feel tight. After filling the tank, it may settle some, so recheck for leaks and tightness.