Product Description

ZeroWater is the only pitcher with filters certified to reduce Lead and Chromium. Be prepared to taste the best tasting water like never before we guarantee it! Unlike conventional gravity-fed water filters, ZeroWaters patented 5-stage ion-exchange filter delivers the only filtered water to measure absolute 000 on the TDS meter. Compare that to the levels youll find in other filtered waters, most bottled waters and plain unfiltered tap waterall of which contain measurable amounts of dissolved substances. Meter readings for tap water average between 75 and 300. Conventional filtered water measures between 030-500, and bottle water between 000-350. The sleek design on the 23-Cup Dispenser allows you to get you water without taking it out of the refrigerator. The Dispenser has a spot on the front allowing access to water without removing the product from the refrigerator. The Dispenser comes with the following products: One ZeroWater filter cartridge that removes contaminants that cause water to have an unpleasant taste; An independently made Electronic Water Tester that test for totally dissolved solids in the water. This TDS Meter offers peace of mind that your ZeroWater filter cartridges are working properly. It also lets you know when to replace the filters. When your water starts reading 006 its time for a change. More complete filtration than ordinary carbon filters for a clean, crisp taste. Certified to NSF Standard 53 to reduce specific health-related contaminants such Lead, Chromium and Mercury. Certified to NSF Standard 42 to reduce contaminants like Hydrogen Sulfide, Chlorine Taste and Odor. Use & Care Instructions for all ZeroWater Pitchers and Devices: ASSEMBLY: Remove lid and water reservoir from top of pitcher and remove filter from packaging. Twist filter into bottom of reservoir from below and tighten filter to obtain a complete seal with the reservoir. Do not drop the filter in from above. Tighten until there is a complete seal between the filter, O-ring and reservoir. Fill reservoir with cold tap water and place lid on top. Allow all water to pass through the filter before filling again. Dispense by pressing the spigot button to fill your cup or glass once the reservoir has emptied into the bottom. CLEANING: Clean your device in warm water using mild soap. Rinse and dry thoroughly. FAQ: Not getting a "000" reading? Ensure that the filter is threaded correctly and fully seated in the water reservoir. Watch for cross-threading and ensure the black rubber gasket is seated properly and has not gotten stuck in one of the threads. Leaky spigot? Empty the water and ensure the spigot is firmly tightened to the device. Contact customer service if leaking continues. Reduce breakage: Do not place anything too heavy on top of your device. TDS Meter or Digital Light Indicator: The TDS meter is intended to measure total dissolved solids. Test your water regularly with the meter. For digital reading meters, change your filter when it reads 006 or higher. For light-up indicators, change your filter when the indicator lights up. Funny taste or smell from the water? Check your water's TDS reading. It's probably time to change the filter. If your water is testing below 006 or the indicator is not lighting up, please contact customer service for a replacement. Slow filtration? Due to the 5-stage technology, ZeroWater filters do have a slower flow rate, which ensures the purest-tasting water. Conventional filters with 2 stages will flow much faster, but will also not remove 99.6% of contaminants as ZeroWater will. If your water is not flowing through at all, you may have an air bubble. Putting some water on top of the filter and squeezing the filter to allow the bubble through should break up the air lock. Filter life will depend on two variables - how good (or bad) your water is and how often you fill up your device.